Table of Contents
Advertisement
Figure 86. Installing the power interposer board
Next steps
1. Reconnect the power cables to the PIB and route the cables properly to avoid cable damage.
2.
Install the air
shroud.
3.
Replace the
PSU.
4. Follow the procedure that is listed in
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to
the manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
96
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
