Dell EMC PowerEdge T350 3RRTM Installation And Service Manual page 13

Table 3. Rear view of the system (continued)
Item Ports, panels, or slots
5 System identification
button
6 NIC port (1)
7 USB 3.0 port (1)
8 USB 2.0 port (1)
9 NIC port (2)
10 iDRAC ethernet port
11 VGA port
12 Serial port
Icon Description
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for 16 seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID button
is enabled in the iDRAC setup.
● If the system stops responding during POST, press and hold the
system ID button (for more than five seconds) to enter the BIOS
progress mode.
The NIC ports are embedded on the LOM card that is connected to the
system board.
The USB ports are 9-pin, 3.0-compliant. These ports enable you to
connect USB devices to the system.
The USB ports are 4-pin, 2.0-compliant. These ports enable you to
connect USB devices to the system.
The NIC ports are embedded on the LOM card that is connected to the
system board.
Enables you to remotely access iDRAC. For more information, see the
Integrated Dell Remote Access Controller User's Guide at
poweredgemanuals.
Enables you to connect a display device to the system. For more
information about the VGA port, see the Dell EMC PowerEdge T350
Technical Specifications on product documentation page.
Enables you to connect a serial device to the system. For more
information about the Serial port, see the Dell EMC PowerEdge T350
Technical Specifications on product documentation page.
PowerEdge T350 system overview
www.dell.com/
13