Removing The Drive From The Drive Carrier - Dell EMC PowerEdge T350 3RRTM Installation And Service Manual

Figure 25. Installing a drive carrier
Next steps
Install the front bezel.

Removing the drive from the drive carrier

Prerequisites
1. Follow the safety guidelines listed in
2. Remove the front bezel.
3. Remove the drive carrier.
Steps
1. Using a Phillips 1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screw driver to remove the drive.
2. Lift the drive out of the drive carrier.
Safety instructions.
Installing and removing system components 41