Configuration (Dmx); Dmx Personality And Starting Address; D-Fi Usb Connectivity; D-Fi Usb Compatibility - Chauvet DJ COREpar Q120 ILS User Manual

Hide thumbs Also See for COREpar Q120 ILS:
Table of Contents

Advertisement

Operation

Configuration (DMX)

The COREpar Q120 ILS works with a DMX controller. Information about DMX is in the CHAUVET DMX
Primer, which is available from the Chauvet website: www.chauvetdj.com.

DMX Personality and Starting Address

When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If you choose a starting address that is too high, you could restrict the access to some of the
product's channels.
The COREpar Q120 ILS uses up to 9 DMX channels in a 9Ch DMX mode, which defines the highest
configurable address to 504.
If you are not familiar with the DMX protocol, download the DMX Primer from: www.chauvetdj.com.
To select the starting address, do the following:
1.
Press <MENU> repeatedly until 4Ch or 9Ch shows on the display.
2.
Press <ENTER> and d 1–504 will show on the display.
3.
Use <UP> or <DOWN> to select the starting address.
4.
Press <ENTER>.

D-Fi USB Connectivity

The COREpar Q120 ILS is able to become a D-Fi wireless receiver/transmitter with the use of the D-Fi
USB from Chauvet DJ. Simply set the product's DMX Personality and DMX Address, set the DIP switch D-
Fi receiving/transmitting channel, then plug it into the D-Fi USB port.
WARNING! DO NOT plug anything other than a D-Fi USB into the USB port. Doing so may
cause damage to the product.
Once plugged in, the D-Fi USB will take over the product. Wired DMX and manual display
control / menu buttons will be unavailable until you unplug the D-Fi USB. The priority
levels are:
1. D-Fi USB
2. Wired DMX
3. Manual Digital Display/Menu Buttons

D-Fi USB Compatibility

The D-Fi USB can receive a DMX signal from the D-Fi Hub and the FlareCON Air 2 as well as other D-Fi
USB products.

Configuration (D-Fi USB)

1. Set the DMX Personality and DMX address on the COREpar Q120 ILS .
2. Use the Chart provided to set BOTH:
the Channel, and then
The Receiving or Transmitting option
NOTE: DIP Switch 5 is for Transmitting OR Receiving, please choose carefully.
COREpar Q120 ILS User Manual Rev. 1
Page 9 of 17

Advertisement

Table of Contents
loading

Table of Contents