Before You Begin
Safety Notes
■
ALWAYS:
♦
Connect to a grounded circuit.
♦
Connect to operating voltages as specified on the product's spec sticker.
♦
Disconnect from power before replacing the fuse.
♦
Disconnect from its power source during periods of inactivity.
♦
Use a safety cable when suspending overhead.
♦
Heed all restrictions and warnings on the spec sticker.
♦
Mount in a location with at least 20 in (50 cm) of ventilation.
♦
Replace the fuse with the same type and rating.
♦
Use a clamp with a captive bolt when a single hanging bracket is used.
■
In the event of a serious operating problem, stop using immediately.
■
DO NOT:
♦
Open this product or attempt any repairs. It contains no user-serviceable parts.
♦
Look at the light source when the product is on.
♦
Use if the power cord is crimped or damaged.
♦
Disconnect by pulling on the power cord.
♦
Allow flammable materials close to the product when it is operating.
♦
Touch the housing when it is on.
♦
Block any ventilation holes/slots in the housing.
♦
Connect to a dimmer or rheostat.
♦
Carry the product by its power cord.
♦
Operate in temperatures higher than 104°F (40°C).
♦
Expose to environments that exceed the Ingress Protection (IP) rating.
♦
Expose to rain or moisture.
♦
Use outdoors.
♦
Submerge.
♦
Leave outdoors for extended periods of time.
♦
Expose to corrosive environmental conditions such as temperature, humidity, salinity,
pressure, radiation, or shock.
♦
Set this product on a flammable surface.
Keep this User Manual for future use. If you sell the product to someone else, be sure that
they also receive this document.
COREpar Q120 ILS User Manual Rev. 1
Page 3 of 17