Table of Contents
Advertisement
3.3
Confirmation of USB Driver Installation
After installing the two types of drivers, check that the drivers have been installed normally, according to the
procedure below. When using the FPL2, the information to be checked here is needed.
Click the "Device Manager" tab and check that the drivers are installed normally.
Cautions 1. When using the FPL2 in Windows 98/Me, do not select
communicating with the target device.
2. When using the FPL2 in Windows 2000/XP, do not perform "Scan for hardware changes" when
communicating with the target device.
Remark
If the drivers above are not displayed, or the mark "×" or "!" is prefixed, refer to CHAPTER 9
TROUBLESHOOTING.
CHAPTER 3 SOFTWARE INSTALLATION
Figure 3-26. Device Manager
User's Manual U17307EJ2V0UM
Check that "NEC Electronics IE-PC Interface
[PG-FPL2]" is present.
Refresh
or
Remove
when
31
Advertisement
Table of Contents
