Table of Contents
Advertisement
CHAPTER 4 OPERATION USING GUI SOFTWARE
<4> Operation Mode
The flash memory may be divided into blocks or areas depending on the target device.
This menu is used to select the operation mode of the flash memory. Some devices do not have
either or both division modes Block and Area. In this case, a mode that is not available cannot be
selected.
Figure 4-10. Device Setup Window – Operation Mode Selection
[When Chip is selected]
The entire flash memory area of the target device is subject to rewrite processing.
[When Block is selected]
Specify the Block number range subject to rewrite processing by using Start/End.
The Start/End list boxes display the Block number where the flash memory of the target device is
configured.
Remark The Start Block number is fixed to 000. Specify the End Block number only.
[When Area is selected]
This item is not supported.
[Show Address check box]
Specifies whether numbers or addresses are displayed in the Start/End list boxes.
If this check box is checked, addresses are displayed.
If it is not checked, numbers are displayed.
43
User's Manual U17307EJ2V0UM
Advertisement
Table of Contents
