Table of Contents
Advertisement
ORE 2-125 EC / OSE 2-80 EC / ODE 2-100 EC
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
Technical specifications
See figure B
Overview (see figure A)
The numbering of the product features refers
to the illustration of the machine on the
graphics page.
1
Insulated grip surfaces
2
ON/OFF Switch
3
Extraction nozzle
4
Speed setting button
5
Speed control panel
6
Sanding plate
7
Sanding sheet
8
Microfilter box
a) Housing
b) Filter insert with cover
Operating instructions
NOTE
When the power tool is switched off, the tool
continues running briefly.
For further information on the manufacturer's
products go to www.flex-tools.com.
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Before switching on the power
tool
Pull out the mains plug and check that there
are no missing or damaged parts.
Attaching/changing the sanding
sheet
The sanding plate has Velcro fasteners and is
therefore designed exclusively for use with
Velcro sanding sheet (see figure C1&C2&C3).
– Pull out the mains plug.
– Remove used sanding sheet.
– Remove any coarse debris from the
sanding plate.
– Attach new sanding sheet. Align the holes
in the sanding sheet with the holes in the
sanding plate.
– Attach the sanding sheet by gently pressing it
against the Velcro fasteners on the sanding plate.
Changing the sanding plate
If the sanding plate has worn out, it can be
replaced (see figure D).
– Pull out the mains plug.
– Undo the four screws.
– Remove the sanding plate by pulling it
downwards.
– Attach a new sanding plate.
– Tighten the four screws back.
Integrated extractor with
microfilter box
– Push microfilter box all the way onto the
extraction nozzle (see figure E).
To ensure optimum dust extraction, empty the
microfilter box in good time! Regularly clean
filter element.
– Pull microfilter box with a twisting movement
off the extraction nozzle.
– Remove cover (bayonet lock) and pull out
together with the filter element.
– Tap filter element on a solid surface.
– Clean fins with a soft brush.
– Empty housing of the microfilter box.
– Reattach microfilter box (see figure F).
Setting the speed
There are four speed levels that can be
changed using the speed setting buttons.
Press the "+"button to increase the speed.
Press "-" button to decrease the speed. The
LED lights above the numbers indicate the
current speed level (see figure G).
The speed level can be set when the tool is
connected to the power supply or when the
tool is already in operation.
After you turn the tool off, the memory function
will remember and revert to the last active
speed level the next time the tool is turned on.
The approximate OPM (oscillations per
minute) are:
Speed level
1
2
3
4
/min (OPM)
8000
9300
10600
12000
13
Advertisement
Table of Contents
