Installation And Connection; Ac Power Connection; Signal Cable Connection; Connecting To Any Ibm Vga Compatible System - Mitsubishi Diamond Pro 710 User Manual

3 INSTALLATION AND
3
CONNECTION
On the back of the monitor two kinds of connections are
provided: AC power connector for the AC input and DB9-
15P connector for video signal input.
3.1

AC Power Connection

One end of the AC power cord is connected to the AC
power connector on the back of the monitor. The other end
is plugged into a properly grounded three-prong AC outlet.
The monitor's auto-sensing power supply can automati-
cally detect 100-120V AC or 220-240V AC and 50 or 60Hz.
CAUTION
The socket-outlet shall be installed near the equipment
and shall be easily accessible. During servicing, discon-
nect the plug from the socket-outlet.
Méme si le moniteur est mis hors tension il reste toujours
alimenté. La prise secteur devrait ainsi ètre facilement
accssible en cas d'urgence.
3.2

Signal Cable Connection

The attached signal cable provides a DB9-15P connector
for the VGA compatible analog RGB outputs on your
computer.

3.2.1 Connecting to Any IBM VGA Compatible System

Figure 5 shows the signal cable connection to the Video
Graphics Adapter (VGA) port.
1. Power off, both the monitor and the computer.
2. Connect the one end of the signal cable to the DB9-
15P connector on the VGA controller card.
3. Power on the monitor, then the computer.
4. After using the system, power off the monitor, and the
computer.
SIGNAL CABLE
Power Cord
Figure 5
Computer
VGA
Compatible
System
DB9-15P
- 6 -

3.2.2 Connecting to An Apple Macintosh Computer

Figure 6 shows the signal cable and AD-A205
Adapter(option) to the video port in an Apple Macintosh.
1. Power off, both the monitor and the computer.
2. Set the DIP switches of the optional Macintosh Adapter
according to the setting chart.
(See 7.2 Optional Macintosh Adapter AD-A205 set-
tings)
3. Connect the 15-pin (DB-15P) end of the AD-A205
Adapter to the straight 15-pin connector on the
Macintosh video port on the computer or on the video
board.
4. Connect the sub-miniature 15-pin (DB9-15P) end of
the optional AD-A205 Adapter to the signal cable.
5. Power on the monitor, then the Macintosh.
6. After using the system, power off the monitor, and the
Macintosh.
• For the Apple Macintosh Computers having a VGA
compatible port, steps 2 through 4 are not necessary.
Connect the end of the signal cable to the port directly.
• In case of Apple Macintosh G3 series, use "Control
Panel" of "Apple Menu" when selecting a resolution.
If select the resolution from "Control Bar", no screen
may be displayed and the computer may freeze.
Power Cord SIGNAL CABLE
Figure 6
Computer
Apple Macintosh
Computer
AD-A205
ON
1 2 3 4 5 6
MITSUBISHI
Macintosh
Adapter
AD-A205
(Option)