Degaussing; Connection Of Signal Cables - Mitsubishi HL7925K Series User Manual

[ INSTALLATION
2.5 Degaussing
(
Degaussing is required whenever the monitor is installed or moved )
to other place. Degaussing procedure is explained in 3.1 (J).
When it is necessary to degauss the monitor absolutely, it is advised to use a
degaussor.
The procedure of degaussing used by a degaussor is as follows.
( 1) The degaussor should be turned on more than six feet away from the
monitor.
(2) Approach it to the monitor with moving in a circular motion, then move it
around slowly along the screen, top and sides of the monitor a few times.
(3) Take back the degaussor from the monitor gradually with moving in a
circular motion, then turn it off more than six feet away from the monitor.
2.6 Connection of Signal Cables
The signal cable should be made with 75 ohm coaxial cable.
(Type RG59/U or equivalent)
(1) IN CASE OF A COMPOSITE SYNC. SIGNAL
ON GREEN VIDEO SIGNAL
Connect R,G,B video signals to BNC receptacles on rear panel respectively.
Set 2 Kn/HIGH select SW to "2 Kn" position.
15Q R 75Q B
75Q .
G
~~
HIGH
~~
HIGH
~~
HIGH
9
COMP
HD
~
2Kn VD
~~
HIGH
HOST COMPUTER
CONTROLLER
PERSONAL COMPUTER
]