RadioLink T8FB Instruction Manual page 3

Note:About flying
While you are getting ready to fly, if you place your transmitter on the ground ,be sure
that the wind won't tip it over. If it is knocked over, the throttle stick may be
accidentally moved, causing the engine to speed up. Also, damage to your transmitter
may occur.
Other than 2.4GHz system: Before operating, be sure to extend the transmitter
antenna to its full length, collapsed antenna will reduce your flying range and cause a
loss of control.It is a good idea to avoid pointing the transmitter antenna directly at the
model, since the signal is weakest in that direction.
In order to maintain complete control of your aircraft it is important that it remains
visible at all times .
Flying behind large objects such as buildings, grain bins, etc. are not suggested.
Doing so may result in the reduction of the quality of the radio frequency link to the
model.
2.4GHz system: Do not grasp the transmitter module's antenna during flight.Doing so
may degrade the quality of the radio frequency transmission.
2.4GHz system: As with all radio frequency transmissions, the strongest area of signal
transmission is from the sides of the 8CH transmitter module's antenna. As such, the
antenna should not be pointed directly at the model.If your flying style creates this
situation,easily move the antenna to correct this situation.
Warning!!!
This product is not a toy and is not suitable for children under the age of 18.
Adults should keep the product out of the reach of children and exercise caution
when operating this product in the presence of children.
Please don't fly in the rain! Rain or moisture may enter the transmitter internal
through gaps in the antenna or joystick flight and cause your flight to instability even
out of control. If inevitable will fly in the wet weather (such as game), please be sure
to use plastic bags or waterproof cloth to cover your transmitter, please don't flight if
there is lightning.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
2