Guidelines To Mount The Servos, Receiver And Battery - RadioLink T8FB Instruction Manual

Push two sticks from the highest position to the lowest position, and then put sticks
to the center position. (P1)
（P1）
2) Center position calibration:
Put stick to the center position, press rudder trimmer right, and then red and green
LED always on means sticks calibrate successful.

1.3 Guidelines to mount the servos, receiver and battery

• Make certain the alignment tab on the battery, switch and servo connectors is orient
correctly and 'key' into the corresponding notch in the receiver or connectors before
plugging them in.When unplugging connectors, never pull on the wires. Always pull
on the plastic connector instead.
• Receiver's Antenna: In generally receiver's antenna is longer than remote
control,don't break or retract it,otherwise shorten the control distance.The antenna
must be kept away from conductive materials,such as metal. Please make distance test
before flying.
•If your aileron servos are too far away to plug into the receiver,use an aileron
extension cord to extend the length. Avoid plugging multiple extensions together to
obtain your desired length. If the distance is greater than 50cm or high current draw
servos are being used, use heavy servo extensions.
• Receiver Vibration and Waterproofing: the receiver contains precision electronic
part.Be sure to avoid vibration,shock,and temperature extremes.For protection, wrap
the receiver in foam rubber or other vibration-absorbing materials. It is also a good
idea to waterproof the receiver by placing it in a plastic bag and securing the open end
of the bag with a rubber band before wrapping it with foam rubber. If you accidentally
get moisture or fuel inside the receiver,you may experience intermittent operation or a
crash. If in doubt, please contact Radiolink after-sales or distributors for service.
• Always mount the servos with the supplied rubber grommets. Don't over tighten the
screws. No part of the servo casing should contact the mounting rails, servo tray or
any part of structure. Otherwise vibration will be transmitted to the servo causing
damage of servo. Note the small numbers (1,2,3,4) molded into each arm on the servo
9