Optional Installation; Inside Lock; Step Plate; Pull Down Rope - Wayne-Dalton 464 Installation Instructions And Owner's Manual

Optional Installation

Inside Lock

Install the inside lock on the second section of the door. Secure the lock to the section with
(4) 1/4" - 20 x 5/8" self drilling screws. Square the lock assembly with the door section, and
align with the square hole in the vertical track. The inside lock should be spaced approxi-
mately 1/8" away from the section edge.
IMPORTANT: INSIDE LOCK(S) MUST BE REMOVED OR MADE INOPERATIVE IN THE UN-
LOCKED POSITION IF AN OPERATOR IS INSTALLED ON THIS DOOR.
Second section
Inside lock
End stile

Step Plate

Position your step plate on the inside of the door over the bottom section endstile and on the
side of the door containing the side lock. Secure the step plate to endstile using (2) 1/4" - 20
x 5/8" self-drilling screws, as shown. For doors ordered with non-keyed locks, a second step
plate is provided. Install the second step plate in the same manner as the first on the lock
section (second section), below the side lock.
Step plate
(2) 1/4"-20 x 5/8"
Self drilling screws
Step plate
(2) 1/4"-20 x 5/8"
Self drilling screws

Pull Down Rope

WARNING
DO NOT INSTALL PULL DOWN ROPE ON DOORS WITH OPERATORS.
CHILDREN MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR
FATAL INJURY.
Measure and mark the jamb approximately 48" to 50" (1220 to 1270 mm) from floor on the
right or left side of jamb. Drill 1/8" pilot hole for no. 6 screw eye. Tie the pull down rope to the
no. 6 screw eye and to the bottom corner bracket, as shown.
Square hole in
vertical track
(4) 1/4"-20 x 5/8"
Self drilling screws
1/8"
End stile
Lock Section
(Second section)
End stile
Bottom Section
22
No. 6
Screw eye
48" to 50"
From floor
Pull down
rope

Exhaust Port

Using the illustrations below, locate and install the exhaust port assembly to the bottom sec-
tion, using #10 counter sunk bolts and #10 hex nuts, as shown.
NOTE: The exhaust port goes on the inside of the bottom section and can be installed into
the aluminum panel or on a double wide bottom rail.
(3) #10
nuts
1 / 2
" S
e c t
i o n
Exhaust
h e
port
i g h
t
hole
Typical
bottom
sections
shown
Exhaust
Aluminum
port flange
panel
(3) #10
Counter
(3) #10 Counter
sunk bolts
sunk bolts
Outside surface of
#10 Hex
nuts

Chain Hoist

Chain Hoist Installation (Standard Lift Applications only!)
NOTE: Reference separate instructions for Chain Hoists and Jack Shaft Operators installation
instruction.
Chain Hoists and Jack Shaft Operators are limited to:
1.) Standard Lift Doors with roof pitch track 2:12 or greater.
2.) High Lift track greater than or equal to 24".
3.) High Lift track 12" thru 24" with roof pitch track 1:12.
IMPORTANT: IF YOUR DOOR IS TO BE TROLLEY OPERATED, IT IS RECOMMENDED THAT A
OPTIONAL STRUT BE INSTALLED ON THE TOP SECTION.
Typical bottom
corner bracket
Pull down
rope
Gasket
(3) #10
Exhaust
port hole
Exhaust port flange
Exhaust
port
#10 Counter
sunk bolts
bottom section
Gasket
Inside surface
of bottom
section
nuts
Gasket
Double
wide
bottom
rail
Screw
Front
cover