Optional Installation; Trolley Arm Hookup; Inside Lock; Pull Down Rope - Wayne-Dalton 8300 Installation Instructions And Owner's Manual

Optional Installation

Trolley Arm Hookup

NOTE: If Wayne Dalton operator / trolley bracket was installed, follow these directions.
Align hole in the door arm with holes in operator bracket tabs, as shown. Attach with 5/16" x
1-3/4" cotter pin and cotter ring.
Drawbar operator
bracket tabs
5/16" x 1-3/4"
Clevis pin

Inside Lock

Install the inside lock on the second section of the door. Secure the lock to the section with
(4) 1/4" - 20 x 11/16" self drilling screws. Square the lock assembly with the door section,
and align with the square hole in the vertical track. The inside lock should be spaced ap-
proximately 1/8" away from the section edge.
IMPORTANT: INSIDE LOCK(S) MUST BE REMOVED OR MADE INOPERATIVE IN THE UN-
LOCKED POSITION IF AN OPERATOR IS INSTALLED ON THIS DOOR.
Second section
Side lock
End stile

Pull Down Rope

WARNING
DO NOT INSTALL PULL DOWN ROPE ON DOORS WITH OPERATORS.
CHILDREN MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR
FATAL INJURY.
Measure and mark the jamb approximately 48" to 50" (1220 to 1270 mm) from floor on the
right or left side of jamb. Drill 1/8" pilot hole for no. 6 screw eye. Tie the pull down rope to the
no. 6 screw eye and to the bottom corner bracket, as shown.
No. 6 Screw eye
48" to 50"
From floor
Pull
down
rope
5/16" x 1-3/4"
Clevis pin
Cotter
ring
Cotter ring
Door arm
Square hole in
vertical track
(4) 1/4"-20 x 11/16"
Self drilling screws
1/8"
Typical bottom
corner bracket
Pull down
rope
19