KTM 1290 Super Adventure S Owner's Manual page 301

Faults
Malfunction indicator lamp
lights up
The ABS warning lamp lights
up
High oil consumption
12-V battery discharged
Possible cause
Error in the electronic fuel
injection
ABS fuse is blown
Wheel speeds of front and rear
wheels differ greatly
Malfunction in ABS
Engine oil level too high
Engine oil too thin (low viscos-
ity)
A power consumer is connected
to the socket/ACC1.
The hazard warning flasher is
switched on
The 12-V battery is not being
charged by the alternator
Ignition was not switched off
when vehicle was parked
TROUBLESHOOTING 22
Action
–
Read out the fault memory using the
KTM diagnostics tool.
–
Change the fuses in the fuse box.
( p. 262)
–
Stop, switch off the ignition, start
again.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Check the engine oil level. (
–
Change the engine oil and the oil filter,
clean the oil screens. (
–
Disconnect the power consumer from
the socket/ACC1.
–
Charge the 12-V battery.
–
Switch off the hazard warning flasher.
–
Charge the 12-V battery.
–
Check the charging voltage.
–
Charge the 12-V battery.
p. 277)
p. 278)
( p. 253)
( p. 253)
( p. 253)
299