Safety Information; Supplies Required - Bradley Verge Crestt Series Installation Manual

Verge™ Faucets

Safety Information

Warning
Make sure that all water supply lines have been flushed and then completely turned off before beginning
installation. Debris in supply lines can cause valves to malfunction.
Caution
A DC plug-in adapter (supplied by Bradley) should be used in conjunction with the Bradley supplied faucets. The
DC plug-in adapter supplied by Bradley is 6V DC regulated. Direct connection to 120V/220V 50/60Hz could result in
personal injury and will damage the sensor.
Important
Separate parts from packaging and make sure all parts are accounted for before discarding packaging material. If
any parts are missing, do not begin installation until you obtain the missing parts.
When the faucet is mounted on a fixture with a stainless steel bowl, it is recommended that the bowl have a satin
finish rather than a mirrored or highly polished finish.

Supplies Required

• 120V/220V 50/60Hz power source when using Bradley supplied 120V AC/6V DC plug-in adapter
• Tempered hot and cold supply piping and fittings to solenoid valve (1/2" NPT)
• Pipe fittings, pipe sealant as required
2
9/3/2021 Bradley • 215-1895 Rev. B: ECO 21-02-022
Installation