Microtek ADF-700 User Manual page 3

Placing Paper in the ADF-700
1. Open the top Tray Flap and load the stack of originals on the Document Feed
Tray, with the side to be scanned facing up. Push the stack of papers into the tray,
until the paper's edges touch the feeder rollers.
2. Pull out the top Tray Extender for better paper support if the length of the
originals exceeds 10 inches.
Document Tray
3. Align the material with the center of the top tray by sliding in the two Guide Arms
toward the stacked sheets if the width of the originals is less than 8.5 inches.
Tray Flap
Note: The document feeder is not
designed for scanning photos; doing
so may damage your originals.
Microtek accepts no responsibility for
damage that may arise from misuse of
equipment.
Microtek ADF-700 Installing and Getting Started
Document Feed Tray
Tray Extender
Guide Arms
Paper Guide
(supports paper
sizes including A6,
A5, A4, Letter, and
Legal size)
3