Microtek ADF-700 User Manual page 2

2 Microtek ADF-700 Installing and Getting Started
2. Carefully align and insert the feeder
studs into the hinge slots originally
used by the scanner cover.
3. Remove the protective film from the
transparent cover of the scan
sensor area, then lower the
ADF-700.
4. Plug the feeder's connector into the
15-pin Accessory port at the back
panel of the scanner. Secure the
connector by tightening the
retaining screws.
5. Turn on your scanner, and wait for the light on the scanner's front panel to stop
blinking and stay on steady. Your system will detect the scanner with ADF-700
automatically, indicating that the ADF-700 is ready to be used.
Protective Film
15-pin connector