Microtek ADF-700 User Manual

Microtek ADF-700
The ADF-700 is a sheet feeder accessory for the Microtek ScanMaker i700.
The ADF-700 allows automatic scanning of up to 50 sheets of original scan material
from A6 size (4.14" x 5.83") up to legal size (8.5" x 14"). Sheets to be scanned are fed
from the feeder's top tray, guided and scanned as they pass the scanner's image
sensor, and then exit into the feeder's bottom tray.
The ADF-700 installs easily by mounting onto the top of the ScanMaker i700 in place
of the scanner lid, which is removed to make way for the document feeder.
Before you proceed with installation of ADF-
700, make sure your scanner is turned off.
Trademarks
1. Remove the scanner lid. To do so, open the
Microtek ® , ScanMaker, and
®
ScanWizard are trademarks
or registered trademarks of
Microtek International, Inc.
All other products or name
brands are trademarks of
their respective holders.
Important
Documents you scan may be
protected under copyright
law. The unauthorized use of
such documents could be a
violation of the rights of the
copyright holder. Microtek
bears no responsibility for
the unauthorized use of
copyrighted materials.
Copyright©2004 Microtek International, Inc.
I49-003761A, July 2004
Installing and Getting Started
Introduction

Installing the ADF-700

lid until it stands vertically, then pull
upward to remove.
http://www.microtek.com
Note: Please check the firmware
ADF-700
version on your ScanMaker i700 before
installing the ADF-700. If your firmware
version is below 0.63, download the
firmware updater. When the firmware
update is complete, restart your
computer and continue the installation
of the ADF-700. For more details on
downloading, refer to the Addendum at
the end of this user guide.