Advertisement
Front panel controls
To switch on from standby or to standby
The push button on the left side of the front panel turns the unit on or back into standby/bypass mode. The
blue LED beside the stand-by push button shows that the unit is switched on. It takes approximately 3 seconds
to activate the electronics until it goes into operational mode. If the unit is switched off, line in and line out
sockets are linked together and all the electronics are disconnected from the signal path – pure bypass mode
(galvanic bypass).
VNRS
VNRS stands for "Vinyl Noise Reduction System". If the button is pressed, the system is activated and noise
from the played record is reduced. VNRS can reduce vinyl surface noise and turntable drive noise up to 6dB,
while played music stays practically untouched. The LED shows the on/off status of the VNRS.
De-Crackle
The De-Crackle function allows you to reduce crackling sounds coming from the record. You can adjust the
sensitivity of the algorithm by turning the potentiometer. Normal working position is in the center. If you turn it
fully counter-clockwise (left), the algorithm is switched off. (This position is usable if you are playing a perfectly
intact record and only want to use VNRS.)
If you are playing a slightly used or slightly damaged record, you must find the optimal position in which the
music stays untouched, but the crackling is reduced. Start in the center position. Detected crackle and clicks
are indicated by the red LED located right beside the De-Crackle control. If the LED blinks, crackling was
detected and reduced. Find the position in which crackling is reduced sufficiently, but the music stays
subjectively untouched (with no audible distortion). This position is usually +/-30 degrees left or right from the
center position.
The optimal position depends on the status of the used record, type of cartridge and type of phono preamplifier.
Optimal position can slightly vary from track to track on the record. In low level parts of the music and between
tracks, the De-Crackling system is more sensitive. In this situation, the crackle detection LED blinks more often.
If you want to compare the sound with and without this device, simply switch it OFF. The galvanic bypass takes
place, and you can directly compare it to the dry signal. After switching ON, it is necessary to wait about 3
seconds until the operation mode is active.
Intensity
The De-Crackle algorithm can be used in two intensity levels for reducing of detected crackling. If the Intensity
button is not pressed, the basic intensity level is used. If the Intensity button is pressed, the advanced level
(stronger) is used. The advanced level is more effective, but could affect the music. For most new or slightly
used records, the basic level should be fine. For used records, switch to advanced level. Try to fine tune De-
Crackle control individually. Listen in both positions and choose subjectively better one for each record. If
advanced intensity level is activated, indication LED lit.
© Pro-Ject Audio Systems · Vinyl NRS Box S3 · Revision 2022.05.09
3
Advertisement
