Front Panel Controls; Input Selector; Connecting A Headphone; Bluetooth Connection - Pro-Ject Audio Systems BOX-DESIGN Stereo Box DS2 Instructions For Use Manual

Front panel controls

Input selector

After the unit is powered on, pressing the buttons
input.
Volume
Adjust the volume to the desired level, using the large knob on the front panel.

Connecting a headphone

Connect the headphones to the ¼" (6,3mm ) jack socket on the front of the unit. Once headphone jack is
connected into the socket, rear panel outputs are muted.
+6dB button
gain of the preamplifier for all inputs is increased by 6dB if pressed

Bluetooth connection

Make sure the antenna is attached to its connector In5 BT on the back panel prior using Bluetooth. If the Pair
LED is on, active audio connection with Bluetooth device is established.
Pairing with Android devices
Open Settings and tap on Bluetooth. Turn on Bluetooth and tap on Scan. Searched devices will show up.
Tap on Stereo Box DS2 and confirm presented pairing code on your Android device. Then press Pair button
on MaiA DS (alternatively Blank button on remote control) when the blue Pair LED starts blinking. When
paired with Stereo Box DS2, your Android device will show "Connected to media Audio". Now you can play
music from your Android device over Bluetooth to Stereo Box DS2.
Older devices may request a pairing code. Enter "0000" and confirm. No more confirmation on
!
Stereo Box DS2 is then needed.
Bluetooth pairing with Apple devices
Tap on Settings, tap on Bluetooth, turn on Bluetooth. Your device will automatically start searching for
available devices. Tap on Stereo Box DS2 and confirm by pressing Pair button on Stereo Box DS2
(alternatively Blank button on remote control) when the blue Pair LED of is blinking.
A new connection is only possible if the Pair LED is off (it indicates that no device is connected).
!
4
© Pro-Ject Audio Systems · Pro-Ject Stereo Box DS2 · Revision 2019.02.08
◄ ►
and next to the LEDs inputs indicators select desired