Advertisement
-6dB
If the input level is too high, clipping can occur. In this case, the red clip LED located right beside the -6dB
switch blinks and indicates a system overload. In such a situation, please reduce the gain of your phono
preamplifier. If your preamplifier does not have a gain setting, press the -6dB button on your Vinyl NRS Box
S3. Clipping should no longer occur.
Note that this reduction does not affect the bypass mode! Bypass mode will be 6 dB louder than
operational (ON) mode in this case.
Technical specifications Pro-Ject Vinyl NRS Box S3
Internal sampling:
Internal processing:
Frequency response 20Hz to 20 kHz:
Frequency response 30Hz to 20 kHz:
Clip indication:
Bypass mode:
THD:
VNRS noise/rumble reduce:
De-Click reduce (basic):
De-Click reduce (intensity):
Outboard power supply:
Power consumption in standby:
Dimensions: WxHxD (D with sockets):
Weight:
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only if the problem cannot be resolved there, the unit should be
sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
©
2022. All rights reserved.
4
© Pro-Ject Audio Systems · Vinyl NRS Box S3 · Revision 2022.05.09
96 kHz/24 bits
56-bit accumulator, double precision
-0,6 dB / +0,1dB
-0,2 dB / +0,1dB
-0,6 dB below real clipping
galvanic linked together (R
<0,009% (500 mV
Input Level)
rms
up to 8dB (20Hz to 20 kHz)
8 dB (3kHz to 20 kHz)
12 dB (2kHz to 20 kHz)
18V/500mA DC, suitable for your country's mains supply
0W OFF/Standby, 2.2W ON (without outboard power supply)
103 x 37 x 104 (119) mm
340 g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
<0,3 ohm)
link
Advertisement
