Microtek ScanMaker 4700 User Manual page 3

Launching and exiting MSC utility
Launching and Exiting the MSC
utility
Launch your Microtek Scanner Configuration (MSC) utility by:
Double-clicking the Microtek Scanner Configuration (MSC) icon
from the desktop.
Pressing the Cancel/Setup button on your scanner (if your scanner is
equipped with the Cancel/Setup button and the scanner is not
working).
Note: ScanWizard 5 and MSC are programs that run exclusively. This
means that ScanWizard 5 and MSC should be used one at a time and not
simultaneously.
To exit the Microtek Scanner Configuration (MSC) utility:
Click the OK button on the bottom-right corner of the Microtek
Scanner Configuration (MSC) panel. Alternatively you can press the
Cancel/Setup button if your scanner is equipped with this button.
Select "Quit Microtek Scanner Configuration" command from the
"Microtek Scanner Configuration" system menu bar.
Using the Microtek Scanner Configuration (MSC) utility
file:///D|/msc/Launching_exiting_MSC.htm [8/15/03 3:14:18 PM]