Power Cable; Power Cord Connection - Microtek ArtixScan 6000XY Operation Manual

3 Powering Up
This section describes the power up sequence for the ArtixScan 6000XY.

Power cable

The power cable shown below is a North American type that complies with United
States and Canadian requirements. Power cables used in other areas may have a
different look.
Voltage
The ArtixScan 6000XY scanner is preset to the voltage in your country. There is no
need to manually select the voltage; however, make sure that the label next to the
power entry module indicates the correct voltage. Contact your dealer if the label
indicates an incorrect voltage.

Power cord connection

Caution! Make sure your scanner carriage is unlocked prior to connecting it to a
power source.
1. The scanner should be switched to the "OFF" position.
2. At the scanner back panel, connect the power cord.
3. Connect the other end of the power cord to a grounded power source.
Switch the scanner's pow e r t o
t h e " O f f" p o s i t i o n .
ArtixScan 6000XY Installation and Operation Manual 5