Microtek ArtixScan 6000XY Operation Manual page 14

• Use a sharp knife to cut out a window for each original. Make sure not to cut the
mask barcodes.
• With the same method, you can make a mask for different sizes.
• Mount the holder in the scanner with the printed side facing you; insert the 2 right
registration holes of the holder into the registration pins on the scan bed. The right
side of the holder should be aligned with the right side of the glass.
• For more than 20 slides, use the second slide holder.
• Mount the second slide holder on the scanner next to the first holder. Make sure
the jigsaw edges of the 2 holders interlock. See the figure below.
14 ArtixScan 6000XY Installation and Operation Manual
Mask barcodes
area
Make a mask fo r
d i f ferent sizes.
The two guide-holes.