Teeter ComforTrak Series Assembly Instructions Manual page 9

Assemble A-Frame Base & Stretch Max Handles
FIGURE 4
RIGHT
1
2
FRONT
1 ‑ Spreader Arms 2 ‑ Crossbar
FIGURE 5
FIGURE 6
FIGURE 7
LOCKED
LEFT
REAR
FIGURE 4a
UNLOCKED
FIGURE 5a
FIGURE 6a
FIGURE 8
STEP 1
• Follow these instructions if you have an EP‑860, EP‑960,
or EP‑970 model.
• On a level surface, position the A‑Frame so that it is standing upright
and the Stability Feet are on the ground.
• Gently push down on the Spreader Arms to ensure they are fully open
and in the "locked" position (Figure 4).
• Look for temporary circular assembly assistance labels on the
A‑Frame. RIGHT, LEFT, FRONT, and REAR indicate your position while
using the equipment, not facing it. These labels can be removed easily
upon completion of assembly.
• Locate the Handle Assembly Hardware Kit (HK1008).
• Determine the left or right handles, marked with an embossed L / R
on the inside of the black plastic part of each handle.
• Position the lower handle portion of the corresponding handle
(left / right) at the rear junction of the A‑frame leg and Spreader
Arm (Figure 5 & 5a). The Lower Handle Bolt with Spacer has been
assembled loosely so that you will be able to seat the U‑shaped
portion of the lower handle over the Spacer in between the
Spreader Arm and the A‑frame leg. Do not tighten the bolt yet.
• Keeping the lower handle portion seated onto the Spacer, align the
upper handle portion's black plastic part over the outside edge of the
Hinge Plate on the A‑Frame (Figure 6 & 6a).
• Insert and loosely hand‑tighten three of the Allen Head Screws
through the Hinge Plate into the handle (Figure 7).
• Now tighten the Lower Handle Bolt using the Allen Wrench and
Open Wrench provided, ensuring that it is fully secured but not
over‑tightened (Figure 8).
• Finally, tighten the Allen Head Screws for the upper handle using
the Allen Wrench provided.
• Repeat these steps on the other handle.
For EP‑860, EP‑960, & EP‑970 Models
7