Power Management Setup; The Description Of The Power Management - EPOX P55-KV Manual

3-8 CHAPTER 3

3-4 POWER MANAGEMENT SETUP

Choose the "POWER MANAGEMENT SETUP" in the CMOS SETUP
UTILITY to display the following screen. This menu allows the user to modify the
power management parameters and IRQ signals. In general, these parameters
should not be changed unless it is absolutely necessary.
Power Management
PM Control by APM
Video off Option
Video off Method
Conserve Mode
Modem Use IRO
** PM Timers **
HDD Power Down
Doze Mode
Suspend Mode
** PM Events **
VGA
LPT & COM
HDD & FDD
DMA /master
Primary INTR
IRQ3 (COM 2)
IRQ4 (COM 1)
Figure 3-5 POWER MANAGEMENT SETUP
Again, user can move the cursor by pressing direction keys to the field needed to be
modified and press <PgDn> or <PgUp> to alter item selection. You can only change
the content of Doze Mode, Standby Mode, and Suspend Mode when the Power
Management is set to 'User Define'.

3-4-1 The Description of the Power Management

A. Power Management mode selection :
Disabled : The system operates in NORMAL conditions (Non-GREEN)
and the Power Management function is disabled.
Max.saving: This mode will maximize the power saving capability.
Min.saving: This mode will minimize the power saving capability.
User define: Allow user to define timeout parameters to control power saving mode.
Refer to item B shown below.
ROM PCI/ISA BIOS
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
: User Define ** Power Down & Resume Events **
: Yes IRQ5 (LPT 2)
: Suspend -> Off IRQ6 (Floppy Disk)
: V/H SYNC+Blank IRQ7 (LPT 1)
: Disabled IRQ8 (RTC Alarm)
: 3 IRQ9 (IRQ2 Redir)
IRQ10 (Reserved)
: 15 Min IRQ12 (PS/2 Mouse)
: 4 Min IRQ13 (Coprocessor)
: 10 Min IRQ14 (Hard Disk)
IRQ15 (Reserved0
: ON
: LPT /COM
: ON
Esc : Quit
: OFF
: ON F1 : Help
: Primary
F5 : Old Values
: Primary
F7 : Load Setup Defaults
: Primary
: Primary
: Primary
: Disabled
: Secondary
: Secondary
: Primary
: Disabled
: Primary
: Primary
: Select Item
PU/PD/+/- : Modify
(Shift)F2 : Color