Table of Contents
Advertisement
3-8 CHAPTER 3
3-4 POWER MANAGEMENT SETUP
Choose the "POWER MANAGEMENT SETUP" in the CMOS SETUP UTILITY
to display the following screen. This menu allows the user to modify the power
management parameters and IRQ signals. In general, these parameters should not
be changed unless it is absolutely necessary.
Power Management
PM Control by APM
Video off Option
Video off Method
Conserve Mode
Modem Use IRO
** PM Timers **
HDD Power Down
Doze Mode
Suspend Mode
** PM Events **
V G A
LPT & COM
HDD & FDD
DMA /master
Primary INTR
IRQ3 (COM 2)
IRQ4 (COM 1)
Figure 3-5 POWER MANAGEMENT SETUP
Again, user can move the cursor by pressing direction keys to the field needed to be
modified and press <PgDn> or <PgUp> to alter item selection. You can only change
the content of Doze Mode, Standby Mode, and Suspend Mode when the Power
Management is set to 'User Define'.
3-4-1 The Description of the Power Management
A. Power Management mode selection :
Disabled : The system operates in NORMAL conditions (Non-GREEN)
and the Power Management function is disabled.
Max. saving: This mode will maximize the power saving capability.
Min. saving: This mode will minimize the power saving capability.
User define: Allow user to define time-out parameters to control power saving
mode. Refer to item B shown below.
ROM PCI/ISA BIOS
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
: User Define
** Power Down & Resume Events **
: Yes
IRQ5
(LPT 2)
: Suspend -> Off
IRQ6
(Floppy Disk)
: V/H SYNC+Blank IRQ7
(LPT 1)
: Disabled
IRQ8
(RTC Alarm)
: 3
IRQ9
(IRQ2 Redir)
IRQ10 (Reserved)
: Disable
IRQ11
(Reserved)
: Disable
IRQ12 (PS/2 Mouse)
: Disable
IRQ13 (Coprocessor)
IRQ14 (Hard Disk)
IRQ15 (Reserved)
: OFF
: LPT /COM
: OFF
Esc : Quit
: OFF
: ON
F1 : Help
: Primary
F5 : Old Values
: Primary
F7 : Load Setup Defaults
: Primary
: Disabled
: Primary
: Disabled
: Primary
: Primary
: Primary
: Primary
: Primary
: Primary
: Disabled
: Select Item
PU/PD/+/- : Modify
(Shift)F2 : Color
Advertisement
Table of Contents
