Connecting And Controlling Flex Tubes; Link Cable Guidelines; Single Color - Non-Dim - Acclaim Lighting Flex Tube SC G2 User Manual

CO N NEC T I N G A ND CO NTRO LL I NG FL EX TUBES
Flex Tube strips operate at 24VDC and each strip is supplied with an injection molded 16.4'
(5m) feed cable with bare tails. See page 17 for full power requirements.
L INK C ABLE GU ID E L I NE S
Connection cables (not supplied) used to link Flex Tubes to the power/driver unit should
follow these guidelines:
• Up to 40 feet (12m)
• Up to 100 feet (30.5m)
• Up to 180 feet (55m)
In all cases, ensure that the voltage drop at the fixture end of the link cable is no greater
than 8% (1.92V) of the original 24VDC supply.
FL EX TUBE SC -
Use Acclaim Lighting APS-300-24-IP 24V power supply.
APS-300-24-IP
power supply
unit
Mains input
(100-277VAC
50/60Hz)
18 AWG (0.823mm
14 AWG (2.081mm
12 AWG (3.309mm
NO N-D I M
www.acclaimlighting.com
)
2
)
2
)
2
Up to three Flex Tube SC strips
can be run from a single
APS-300-24-IP power supply unit.
Link cables require 2 cores. See
AWG recommendations above.
11