YUTAKI CASCADE CONTROLLER ATW-YCC-(01-02)
•
Configure circuit 1 and circuit 2 OTC: Disabled, Points, Gradient, Fix.
•
Enable or disable DHW and Swimming Pool.
•
Select the heating source: HP only, HP + EH, HP + Boiler.
•
Configure electrical heater use: Disabled or Backup.
•
Configure Boiler type: Parallel or Serial.
•
Configure Solar Combination options: Disabled, Input Demand, Total Control. (only in case DHW is enabled).
•
Enable or disable Hydraulic separator status.
•
Select Next and press OK button.
•
Configure circuit 1 and circuit 2 options: Disabled, Points, Gradient, Fix.
•
Only available for cooling mode.
•
Enable or disable the desired modules (module 1 is enabled by default)
•
Select Next and press OK button.
•
Enable or disable the individual DHW for each module.
•
Select Next and press OK button.
242
PMML0575 rev.2 - 03/2022