MiLAN MIL-S8TA User Manual

MiLAN MIL-S8TA User Manual

8-port 10/100/1000 base-t unmanaged switch

Advertisement

MIL-S8TA
8-Port 10/100/1000 BASE-T
Unmanaged Switch

User Guide

Rev. A1
2006-09-25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MIL-S8TA and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for MiLAN MIL-S8TA

  • Page 1: User Guide

    MIL-S8TA 8-Port 10/100/1000 BASE-T Unmanaged Switch User Guide Rev. A1 2006-09-25...
  • Page 2 Transition Networks will in no case cover damages arising out of the product being used in a negligent fashion or manner. Trademarks The MiLAN logo and Transition Networks trademarks are registered trademarks of Transition Networks in the United States and/or other countries. To Contact Transition Networks...
  • Page 3: Fcc Statement

    FCC STATEMENT This equipment has been tested and found to comply with the limits for a class A device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a commercial installation.
  • Page 4: Table Of Contents

    Content Introduction ... 1 Features ...1 Package Contents ...2 Hardware Description... 3 Physical Dimensions ...3 Front Panel...3 LEDs Indicators ...3 Rear Panel ...4 Installation ... 6 Attaching Rubber Feet ...6 Mounting on the Wall...6 Power On ...7 Technical Specification ... 8...
  • Page 5: Introduction

    Switch that can be used to build high-performance switched networks. This switch is a store-and-forward device that offers low latency for high-speed networking. The Switch is designed for the core of the network backbone computing environment to solve traffic block problems at SME (small, medium enterprise) businesses.
  • Page 6: Package Contents

    Package Contents Unpack the contents of the switch and verify them against the checklist below. 8-port Switch Power Cord. User Guide. 8-port Switch Compare the contents of your switch package with the standard checklist above. If any item is missing or damaged, please contact your local dealer for service.
  • Page 7: Hardware Description

    Hardware Description Physical Dimensions The physical dimensions of the Switch is 165mm x 100mm x 32.5 mm (L x W x H) Front Panel The front panel of the 8-Port Gigabit switch consists of LED-indicators (100/1000, Link/Activity, Full duplex/Collision) for each Gigabit port and power LED-indicator for unit.
  • Page 8: Rear Panel

    LNK/ACT Blinking Orange FDX/COL Blinking Rear Panel The rear panel of the 8-port Gigabit Switch consists of 8 auto-negotiation 10/100/1000Mbps Ethernet RJ-45 connectors (support Automatic Description Power On Power is not connected The port is operating at the speed of 1000Mbps.
  • Page 9 MDI/MDIX function). RJ-45 Ports (Auto MDI/MDIX): 8 port auto-negotiation 10/100/1000 Mbps Ethernet RJ-45 connectors [Auto MDI/MDIX means that you can connect to another Switch or workstation without changing non-crossover or crossover cabling.]...
  • Page 10: Installation

    Installation This section shows the installation procedures of the switch. Set the Switch on a sufficiently large flat space with a power outlet nearby. The surface where you put your Switch should be clean, smooth, level, and sturdy. Make sure there is enough clearance around the Switch to allow attachment of cables, power cord and air circulation.
  • Page 11: Power On

    Connect the cord of power to the power socket on the rear panel of the Switch. The other side of power cord connects to the power outlet. Check the power indicator on the upper panel to see if power is properly supplied.
  • Page 12: Technical Specification

    Technical Specification The following table provides the technical specification of 8-ports Gigabit Switch. Standard Protocol Technology Transfer Rate Connector MAC Address Memory Buffer Jumbo frame Back plane IEEE 802.3 10BASE-T Ethernet IEEE 802.3u 100BASE-TX Fast Ethernet IEEE 802.3ab Gigabit Ethernet IEEE 802.3x Flow Control and Back-pressure...
  • Page 13 10BASE-T: EIA/TIA-568 100-ohm (100m) 100BASE-TX: Network Cable EIA/TIA-568 100-ohm (100m) Gigabit Copper: EIA/TIA 568 100-ohm (100M) Per port: 100/1000, Link/Activity, Full duplex/ Collision Per unit: Power Power Supply AC 100~240V, 50/60Hz Power 7.6 Watt (maximum) Consumption (DC) Operation to 45 Temperature Operation 10% to 90% (Non-condensing)

Table of Contents