Managed 8 & 9 port switches, eight 10/100base-tx ethernet ports plus one 100base-fx port / eight 10/100base-tx ethernet ports plus one 1000base-sx port / eight 10/100base-tx ethernet ports (88 pages)
Page 2
In no event shall MiLAN Technology be liable for incidental or consequential damages, costs, or expenses arising out of or in connection with the performance of the product delivered hereunder.
Page 3
To Contact MiLAN Technology For prompt response when calling for service information, have the following information ready: Product serial number and revision. Date of purchase and Vendor or place of purchase. You can reach MiLAN Technology technical support at: E-mail: support@milan.com Telephone: +1.408.744.2751 Fax: +1.408.744.2771...
The MIL-S500 Switch provides wire-speed, Fast Ethernet switching function that allows high-performance, low cost connections to full-duplex, half-duplex, 10Mbps and 100Mbps Ethernet network. The MIL-S500 switch provides five auto-sensing 10/100Mbps RJ-45 ports that automatically detects the speed of the device that is plugged into it. This switching function allows 10Mbps, 100Mbps, full-duplex and half-duplex devices to communicate on the same network without having to replace any infrastructure.
MDI/MDIX Auto-recognition (No cross over cable required) Magnets provide easy installation in modular office Package Contents Your package contents should include the following: MIL-S500 Switch Four rubber feet with adhesive pads Two Magnets User’s Guide Figure 2. Package Content...
Figure 3. Front view of MIL-S500 Switch LEDs Per Device Power 100Mbps ( Link on 100Mbps ) Per Port LINK/ACT ( Link/Activity ) The Rear Panel The rear panel of the MIL-S500 Switch has a DC power connector and 5 auto-sensing ports.
Page 7
Figure 4. Rear panel view of the MIL-S500 switch Auto-sensing ports for speed and Duplex Five Auto-sensing RJ-45 ports for 10Base-T or 100Base-TX connections. DC Power Connector Plug this connector female end into this device, and the male into a power outlet.
Blinking LINK/ACT Installation Apply self-adherent rubber feet to the bottom of the Switch near each of the four corners. See Figure 6. If applying Switch to metal surface, install magnets as shown in Figure 6. Switch may then be installed on a metal surface.
Or, you may try to unplug the power cord on the Switch, wait for five seconds and then reconnect. If you still cannot resolve the problem, call our technical support hotline.