Kia Carnival 2022 Owner's Manual page 193

Features of your vehicle
for quicker training and accurate
transmission of the radio-fre -
quency signal.
3. Place the ignition switch or
ENGINE START/STOP button to
the ACC (Accessory) position for
programming of HomeLink.
OKA4040535N
2) Programming a New HomeLink
Button
1. Press and release the HomeLink
button (1), (2) or (3), you would
like to program. The HomeLink
indicator light (7) will flash orange
slowly (if not, perform the steps
of "Erasing HomeLink Buttons"
section, and start over).
OKA4040541N
2. Position the garage door opener
remote 1 - 3 inches (2 - 8 cm)
away from the HomeLink but -
tons.
OKA4040542N
3. While the HomeLink indicator light
(7) is flashing orange, press and
hold the hand-held remote but -
ton. Continue pressing the hand-
held remote button until the
HomeLink indicator light (7) light
changes from orange to green.
You may now release the hand-
held remote button.
4. Wait until your garage door
comes to a complete stop,
regardless of position, before pro -
ceeding to the next steps.
5. Press and release the HomeLink
button you are programming and
observe the indicator light.
If the indicator light remains
solid green, your device should
operate when the HomeLink
button is pressed. At this point,
if your device operates, pro -
gramming is complete.
Mirrors
4
4 85