Advertisement
AP-303H-MNTD.fm Page 2 Monday, February 27, 2017 2:49 PM
Securing the access point to the mount cover
Figure 2
3. Align the slots on the back of the access point to the corresponding posts on the inside of the mount cover
(Figure
slots. When properly attached, the device should be positioned flat against the cover.
4. Insert the two M2.5x12, T8 Hex security screws into the holes on the back of the mount stand and tighten to
anchor the access point to the mount
Anchoring the access point into the mount
Figure 3
5. (Optional) Use the Kensington lock slot located on the back of the mount stand to lock this mount kit to a
secure surface.
© Copyright 2017 Hewlett Packard Enterprise Development LP
0511971-02
2). Press the access point into the cover, then pull down on the device until the posts engage with the
(Figure
3).
AP-303H-MNTD Desk Mount Kit | Installation Guide
Advertisement
