Step
1.
Enter system view.
2.
Enter Ethernet interface
view.
3.
Enable EEE on the
Ethernet interface.
Setting the statistics polling interval
Step
1.
Enter system view.
2.
Enter Ethernet interface
view.
3.
Set the statistics polling
interval for the Ethernet
interface.
To display the interface statistics collected in the most recent statistics polling interval, use the
display interface command.
Forcibly bringing up a fiber port
As shown in
receiving packets. The physical state of the fiber port is up only when both transmit and receive fibers
are physically connected. If one of the fibers is disconnected, the fiber port does not work.
To enable a fiber port to forward traffic over a single link, you can use the port up-mode command.
This command forcibly brings up a fiber port, even when no fiber links or transceiver modules are
present for the fiber port. When one fiber link is present and up, the fiber port can forward packets
over the link unidirectionally.
Command
system-view
interface interface-type
interface-number
eee enable
Command
system-view
interface interface-type
interface-number
flow-interval interval
Figure
2, a GE/10-GE/40-GE/100-GE port uses separate fibers for transmitting and
Remarks
N/A
N/A
By default, the statistics polling
interval is 300 seconds.
15
Remarks
N/A
N/A
By default, EEE is disabled on
an Ethernet interface.