Table of Contents
Advertisement
•
To turn the appliance on, press the
8). The message "Heating up Please wait" appears on the
display (B4).
8
When heating is complete, the message changes to: "RINSING";
As well as heating the boiler, this also heats the internal circuits
by circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coffee appears.
5. TURNING THE APPLIANCE OFF
Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts
(A11). Avoid contact with splashes of water.
•
To turn the appliance off, press the
8).
•
The message "Turning off, Please wait" appears on the dis-
play (B4), then the appliance performs a rinse cycle and
goes off (standby).
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
•
first turn the appliance off by pressing the
(fig. 8);
•
release the main switch at the side of the appliance (fig. 2).
Important!
Never press the main switch while the appliance is on.
6. MENU SETTINGS
6.1 Rinsing
Use this function to deliver hot water from the coffee spouts
(A11) and hot water spout (C6), if inserted, to clean and heat
the appliance's internal circuit. Place a container with a mini-
mum capacity of 100ml under the coffee and hot water spouts.
To enable the function, proceed as follows:
button (A23) (fig.
1. Press the MENU/ESC button (B3) to enter the menu;
2. Press < (B12) or > (B8) (fig. 9) until "Rinsing" appears on the
3. Press the
Important! Danger of burns.
Do not leave the appliance unattended while hot water is being
delivered.
4. Press the
Please note!
•
•
button (A23) (fig.
6.2 Descale
For instructions on descaling, see section "11. Descaling" .
6.3 Install filter
For instructions on how to install the filter (C4), see section"13.1
Installing the filter".
button
6.4 Replacing the water softener filter (if
For instructions on how to replace the filter (C4), see the section
"13.2 Replacing the filter".
6.5 Adjust time
To adjust the time on the display (B4), proceed as follows:
1. Press the MENU/ESC button (B3) to enter the menu;
2. Press < (B12) or > (B8) (fig. 9) until "Adjust time" is
3. Press the
7
display (B4);
9
button (B5). The message "Confirm?" is
displayed;
button (fig. 3): after a few seconds, hot
water is delivered first from the coffee spouts (A11) and
then from the hot water spout (C6) (if inserted). This cleans
and heats the appliance's internal circuit.
To stop delivery at any time, press any button.
If the appliance is not used for more than 3-4 days, we
strongly recommend, when switching on the appliance,
performing 2/3 rinses before using it.
installed)
displayed;
button (B5) (fig. 3): the hours flash on
the display;
Advertisement
Table of Contents
Troubleshooting
