External Power Supply Mode Connection Socket Installation - Zanotti Zero Series Installation Manual

3.13 External power supply mode connection socket installation

DANGER
Do not connect the cable to the power supply during installation.
To install the External power supply plug, proceed as follows:
Using the screws provided, fix the socket (3, Figure 68) to the external wall of the cold room
•
• Position the connecting cable (2) between the socket (3) and the condenser unit (1) and fix it using
the terminals provided
Cut the excess cable
•
CAUTION
Do not roll over the excess cable and do not create junctions.
Consulting the wiring diagram provided, connect the earth, the neutral (if present) and finally the
•
phases.
60
INSTALLATION MANUAL
Figure 68- Installing the External power supply connection socket
Refrigeration unit
Series Zero Direct-Drive
Z200 | Z250 | Z350 | Z380
Z380 Multi
rev.01