Condenser Unit Installation; Nose Installation - Zanotti Zero Series Installation Manual

Refrigeration unit
Series Zero Direct-Drive
Z200 | Z250 | Z350 | Z380
Z380 Multi

3.6 Condenser unit installation

NOTE
The right side of the condenser unit is equipped with a removable door (1, Figure 52)
for the passage of cables and pipes.

3.6.1 Nose installation

To install the condenser unit proceed as follows:
Prepare the installation and passage holes for the pipes and electrical cables, following the model
•
of the refrigeration unit and the installation mode (see 2.1).
• Place the work platform near the truck.
Move the condenser unit, coupled to the lifting device, towards the truck wall.
•
Pass the pipes and the electrical cables connecting the evaporator through the hole (2, Figure
•
53).
Fix the unit with the screws provided.
•
rev.01
INSTALLATION MANUAL
Figure 52 - Right side door of condenser unit
Figure 53 - Piping and electrical cables hole passage
45