Removal And Mounting Of The Flaps Of The Condenser Unit; Removal - Zanotti Zero Series Installation Manual

Refrigeration unit
Series Zero Direct-Drive
Z200 | Z250 | Z350 | Z380
Z380 Multi

3.4 Removal and mounting of the flaps of the condenser unit

CAUTION
DO NOT remove the side frame from the front, as shown in Figure 45, to avoid
damaging the unit.
Follow the procedure below to remove the flap.

3.4.1 Removal

To remove the side frames of the condenser unit, proceed as follows:
Unscrew the screws (A, Figure 46) with the appropriate tool
•
Slide the side to the front wall for at least 3 cm [1.18 in].
•
rev.01
INSTALLATION MANUAL
Figure 45 - Wrong removal of the side frame.
Figure 46 - Fastening screws on the side of the machine
Figure 47 - Sliding the side frame
41