Discharge Heater Installation - Zanotti Zero Series Installation Manual

Refrigeration unit
Series Zero Direct-Drive
Z200 | Z250 | Z350 | Z380
Z380 Multi

3.10.2 Discharge heater installation

In order to prevent the formation of ice inside the condensate drain hoses, it is possible to install a defrost
resistance, if supplied.
The drain resistance ES (6, Figure 62) must be installed in parallel to the defrosting valve YS using
•
the "Y" bridle supplied.
To fix the resistance to the evaporator lid, use aluminium tape, as shown in Figure 64.
•
rev.01
INSTALLATION MANUAL
Figure 64 - Discharge heater mounting
57