DGS-1250 Series Gigabit Ethernet Smart Managed Switch CLI Reference Guide
Copyright(C) 2019 D-Link Corporation. All rights reserved.
User Access Verification
Username:admin
Password:*****
Error Messages
When users issue a command that the Switch does not recognize, error messages will be generated to assist
users with basic information about the mistake that was made. A list of possible error messages are found in the
table below.
Error Message
Ambiguous command
Incomplete command
Invalid input detected at ^marker
The following example shows how an ambiguous command error message is generated.
Switch#show v
Ambiguous command
Switch#
The following example shows how an incomplete command error message is generated.
Switch#show
Incomplete command
Switch#
The following example shows how an invalid input error message is generated.
Switch#show verb
^
Invalid input detected at ^marker
Switch#
Editing Features
The command line interface of this switch supports the following keyboard keystroke editing features.
Keystroke
Delete
Backspace
DGS-1250-28XMP Gigabit Ethernet Smart Managed Switch
Command Line Interface
Firmware: Build 1.00.038
Meaning
Not enough keywords were entered for the Switch to recognize the
command.
The command was not entered with all the required keyword.
The command was entered incorrectly.
Description
Deletes the character under the cursor and shifts the remainder of the line to the
left.
Deletes the character to the left of the cursor and shifts the remainder of the line to
the left.
4