Orca ZEUS ZSW 230 Installation, Maintenance And User Manual page 22

User manual
In the heating mode, two running period scans can be set
Press and hold for 2s to enter into the timer setting interface.
Running period 1: The symbol ON 1 on the right side of the interface and the time parameter flashes at this time.
Press again and the hour parameter flashes. Set the time according to the 2.6 and confirm. Then OFF 1 and
the time parameter flashes. Set the time following the previous steps.
Running period 2: After Running Period 1 is set, the controller will enter into the Running period 2 setting interface.
Set the start – up and shut – down time in the same way as Running period 1.
Press to cancel any modifications during the setting.
Press and hold for 2s twice to set the OFF 1 time directly or press
Press cancel the setting when the hour parameter is flashing.
20
when the unit is already running.
ZEUS