Battery And Charger - Glion Dolly XL User Manual

PROPELLING THE SCOOTER.
IT POWERED ON WITH THE SPEED SETTING AT DEFAULT ECO LEVEL.
Riding the Scooter Powered:
1. Raise the kickstand.
2. Press and hold the power button about two seconds to turn on the scooter. The LCD
screen should be lit when the scooter is turned on. The default speed setting is Eco.
Adjust the speed setting according to your needs.
3. With both hands on the handlebar and one foot located towards the front half of the
standing board and one foot on the ground, manually push the scooter forward and
slowly press the accelerator. The scooter is rear wheel drive. Be sure to have the
foot on the standing board located towards the front of the standing board when
engaging the motor to avoid a wheelie.
4. As the motor begins to slowly propel the scooter forward, place the foot which pushed
off the ground onto the riding board behind your front foot. Press the thumb
accelerator more to increase speed and carefully glide on (Glīon). Remember, as a
safety feature, you will have to manually propel the scooter to get the motor moving
before the electric motor will engage. If you manually propel the scooter and the motor
does not engage, it might be because you did not reach the minimum speed.
Stopping the Scooter:
1. Squeeze the left hand brake to begin the braking process. The harder and faster you
squeeze, the quicker the stopping process. If more braking power is needed, also
squeeze the right hand brake. In a safe, controlled environment, please familiarize
yourself with the braking distance of the scooter at various speeds before operating
near intersections, pedestrians and other obstacles.
WARNING: Always ride at speeds you can comfortably and
safely control. Take the time to familiarize yourself with the hand
brakes and the distance it takes to come to a complete stop at
various speeds. Keep both hands on the handle grips while operating the
scooter at all times. Failure to do so could result in serious injury or death.
Each electric scooter is equipped with a lithium battery and a smart charger designed specifically
for each other. ONLY USE THE CHARGER SUPPLIED BY THE MANUFACTURER TO CHARGE
THE SCOOTER. Do not charge the battery with any other charging system. If the battery or
charger is damaged due to improper use, the limited manufacturer warranty shall be void. Do not
operate the charger near flammable materials such as carpet. Ensure a dry environment. Never
allow the charger or cable to come into contact with water as this may result in electric shock.
Never touch the charger or cable with wet hands. Disconnect the charger from the outlet if any
fault arises during charging. Always pull the plug, not the cable. Do not allow the charger or
cables to be damaged or crushed by sharp edges or heat. The charger supplied with the electric
scooter should be regularly examined for damage to the cord, plug, enclosure and other parts. In
the event of such damage, the scooter must not be charged until the charger has been repaired or
replaced. Unplug the charger and disconnect from the scooter when not in use.
BATTERY:
1. Fully charge the battery before first time operation or first time after a long period of
non-usage (see Instructions For Charging below). For safety reasons, the battery is only
THEN FOLLOW BELOW INSTRUCTIONS AND TRY RIDING

BATTERY AND CHARGER

15