Battery And Charger - Glion 215 User Manual

Each electric scooter is equipped with a lithium battery and a smart charger designed specifically
for each other. ONLY USE THE CHARGER SUPPLIED BY THE MANUFACTURER TO CHARGE
THE SCOOTER. Do not charge the battery with any other charging system. If the battery or
charger is damaged due to improper use, the limited manufacturer warranty shall be void. Do not
operate the charger near flammable materials such as carpet. Ensure a dry environment. Never
allow the charger or cable to come into contact with water as this may result in electric shock.
Never touch the charger or cable with wet hands. Disconnect the charger from the outlet if any
fault arises during charging. Always pull the plug, not the cable. Do not allow the charger or
cables to be damaged or crushed by sharp edges or heat. The charger supplied with the electric
scooter should be regularly examined for damage to the cord, plug, enclosure and other parts. In
the event of such damage, the scooter must not be charged until the charger has been repaired or
replaced. Unplug the charger and disconnect from the scooter when not in use.
BATTERY:
1. Fully charge the battery before first time operation or first time after a long period of
non-usage (see Instructions For Charging below). For safety reasons, the battery is only
50% charged when shipped from the factory. The battery is fully charged when the LED
light on the charger turns green.
2. Always charge the battery in a clean, dry location, free of debris.
3. Charge the battery frequently. The battery can be recharged at any time. Do not think
that you need to fully deplete the battery before recharging it. In fact, frequent partial
discharge/charge cycles will prolong the battery life vs. full discharge/charge cycles.
4. Fully charge the battery before storing the scooter for extended periods.
5. When not in use, periodically recharge the battery once every three months.
6. Battery damage due to water, collision, improper storage and other non-normal factors
is not covered by the limited manufacturer warranty.
CHARGER:
1. When you plug the charger into wall and before you connect it to the scooter, the LED
light on the charge shows blue. The battery is charging the scooter when the LED light
on the charger is red. When the battery is 95% full, it will turn green. It will continue to
charge with very small current for about 30 minutes after the LED turns green. When
battery is 100% full, the charger will stop charging.
BATTERY AND CHARGER
Charge Port
Charger Indicator Light. Green= Near Full
to Full. Blue = Not Connected to Scooter
Red=Still Charging.
17