Fluke 5560A Operator's Manual page 37

To connect the Calibrator to a DUT:
1. If the Calibrator is turned on, push R to remove the output from the Calibrator terminals.
2. Make the connections to the DUT by selecting the appropriate figure from Table
capacitance outputs, null out stray capacitance by connecting the test leads to the DUT, routing
them (but not connecting) to the Calibrator on a non-conductive surface. Null out the reading on the
DUT using rel, offset, or null, whichever method applies, and then connect the test leads to the
Calibrator.
Calibrator Output
Resistance
Capacitance
Inductance (not available on 5540A)
DC or AC Voltage
DC or AC Current <3 A
DC or AC Current ≤3 A
RTD Simulation
Thermocouple Simulation
See the discussion in Four-Wire versus Two-Wire
DUT
INPUT :
HI
LO
A
Figure 3. DUT Connection: Impedance (Four-Wire Compensation)
Table 12. DUT Connections
Connections.
SENSE
4-WIRE
HI
LO
DUT
3 Impedance - four-wire compensated
4 Impedance - two-wire compensated
5 Impedance - compensation off
6 DC Voltage/AC Voltage
7 DC Current/AC Current <3 A
DC Current/AC Current ≥3 A
8
9 Temperature (RTD) - three-terminal connection
10 Temperature (Thermocouple)
SENSE
SOURCE
SOURCE
SENSE
Connect the Calibrator to a DUT
12 For
Figure Reference
Calibrator
Calibrator
31