NEC Express5800/R120h-1M 3rd-Gen Use Precautions page 14

● Notice of NEC ESMPRO Manager (Windows) and Express Report Service (MG) (Windows)
Even in the case of adding this product into NEC ESMPRO Manager (Windows) and Express Report
Service (MG) (Windows) which have already been managing same model product as this product,
updating of NEC ESMPRO Manager (Windows) and iLO Receiving Information (ilo_en.mtb, iml_en.mtb)
may be required because this product which is newly shipped from a factory may have newer version of
iLO firmware. Referring to information below, update the software if it is required.
Regarding the steps of confirmation version of iLO firmware, NEC ESMPRO Manager (Windows), and iLO
receiving information, please refer to the end of this chapter.
◆Restrictions without updating the NEC ESMPRO Manager
iLO NEC ESMPRO
firmware Manager
version (Windows)
Version
2.10 or higher Lower than 6.25
Lower than 6.47
◆Update steps of NEC ESMPRO Manager (Windows)
(1) Download latest version of NEC ESMPRO Manager from the following website.
http://www.58support.nec.co.jp/global/download/index.html
- ESMPRO tab
- NEC ESMPRO Manager
(2) Update NEC ESMPRO Manager. For details refer to Chapter 2 Installation in "NEC ESMPRO
Manager Ver. 6 Installation Guide (Windows) [PDF]".
◆Restriction without updating the iLO Receiving Information
iLO iLO Receiving
firmware Information
version Version
2.10 or higher ilo_en.mtb
Lower than 1.4.0
iml_en.mtb
Lower than 1.50
* There are 2
kinds of iLO
Receiving
Information.
◆Update steps of iLO Receiving Information
(1) Download latest version of iLO Receiving Information(ilo_en.mtb, iml_en.mtb) from the following
website.
http://www.58support.nec.co.jp/global/download/index.html
- ESMPRO tab
- Express Report Service (MG) (Windows) Receiving Information
- iLO.zip
Restrictions
･ Constitution Tab - Server Status screen
"SNMP Alert setting" will show error message "Failed to get SNMP Alert
setting".
･ Remote Control Tab - iLO Information - Show IML or Save IML
NEC ESMPRO Manager will fail to get IML information and Show IML or
Save IML feature will not work.
･ AlertViewer
New Alerts of hardware failure added with firmware update will be displayed
as "Unknown" alert on AlertViewer.
･ AlertViewer
New Alerts of hardware failure added with firmware update will be displayed
as "Unknown" alert on AlertViewer, or they will not be displayed on
AlertViewer.
Restriction
It is impossible to detect a failure of the hardware added along with the update
of hardware and to issue an alert of this failure.
* If iLO Receiving Information has been updated and NEC ESMPRO
Manager has not been updated, it is impossible to detect the failure of the
added hardware and issue the alert of the failure, as with the above.
- 14 -