Endress+Hauser Liquiphant FTL41 Brief Operating Instructions page 12

Mounting
Screwing in the device
• Turn by the hex bolt only, 15 to 30 Nm (11 to 22 lbf ft)
• Do not turn at the housing!
1.
 11 Screwing in the device
Aligning the cable entry
1.
 12 Housing with external locking screw and drip loop
The locking screw is not tightened when the device is delivered.
1. Loosen the external locking screw (maximum 1.5 turns).
2. Turn the housing, align the cable entry.
 Avoid moisture in the housing, provide a loop to allow moisture to drain off.
3. Tighten the external locking screw.
12
2.
2.
Liquiphant FTL41
3.
4 3.5 Nm
Endress+Hauser
A0034852
A0037347