Assembly Ta1100 - Husqvarna 535FBX Operator's Manual

Trimmer head
WARNING:
sure the trimmer line is
wound tightly and evenly
around the drum to
prevent harmful vibration.
To assemble the loop handle
1. Put the loop handle onto the shaft, between the
arrows.
2. Put the spacer into the slot of the loop handle.
3. Install the nut, the knob and the screw. Do not
tighten fully.
4. Adjust the product to an applicable operation
position.
5. Tighten the knob.
To assemble the cutting attachment
guard and trimmer head
1. Attach the correct cutting attachment guard (A) for
the trimmer head (See,
page 39 ).
2. Put the cutting attachment guard onto the fitting on
the shaft.
1301 - 006 - 31.10.2022
Always make

Assembly TA1100

Approved accessories on
• Only use recommended trimmer heads and trimmer
lines.
• Only use recommended cutting attachments.
• Smaller machines requires small trimmer heads and
vice versa.
• The length of the trimmer line is important. A longer
trimmer line requires greater engine power than a
shorter trimmer line of the same diameter.
• Make sure that the cutter on the trimmer guard
is intact. This cuts the trimmer line to the correct
length.
• Soak the trimmer line in water for a couple of days
before use to increase the life length.
3. Secure with the bolt(L).
A
4. Install the drive disc (B) on the output shaft.
5. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
WARNING:
higher section of the drive disc installs
correctly in the center hole of the cutting
attachment. If the cutting attachment
is installed incorrectly, it can result in
serious injury.
6. Put the locking pin (C) in the hole to lock the shaft.
B
C
A
Make sure that the
37