Assembly - Husqvarna 331R Operator's Manual

WARNING: Read the safety chapter before
you assemble the product.
To install the main body
1. Connect the engine (A) to the tube (B) with four
screws (C).
A
B
C
To install the handlebar and throttle
1. Install the handlebar in the handlebar clamp on the
shaft.
2. Install the top part of the handlebar clamp onto the
handlebar. Make sure that the clamp is installed onto
the knurling area of the handlebar. Refer to the
illustration.
3. Put on the harness and hang the product from the
support hook.
1158 - 005 - 26.03.2020

Assembly

4. Make a last adjustment to make sure the product is
in a comfortable position when it hangs from the
harness.
5. Tighten the screws.
To connect the throttle cable and stop
switch wires
1. Remove the air filter cover.
2. Install the throttle cable (A) through the carburettor
bracket (B).
3. Turn the cable adjuster sleeve (C) into the
carburettor bracket fully.
4. Put the slot fitting (D) on the carburettor. At this time,
the recessed hole (E) for the cable lug (F) is away
from the cable adjuster sleeve (C).
5. Rotate the carburettor throttle cam and move the
throttle cable (A) through the slot in the slot fitting.
6. Make sure the cable lug (F) drops into the recessed
hole.
7. Operate the throttle trigger some times to make sure
that it operates correctly.
A B
C
G
D E
F
9