Stitch Designer - Bernina 880 PLUS Workbook

My BERNINA

STITCH DESIGNER

B 8 80 P LU S AND B 790 PLU S ONLY
C re a t i n g Ne w Stit ches- Free- hand Dr awi n g
1. Select the Stitch Designer icon from the
sewing screen.
2.
Touch the New icon to get a fresh page. The Draw tool
(pencil) is the default when entering Stitch Designer.
3.
With your fingertip or stylus, free-hand draw on the
screen to fill the 9 mm boundary. Begin and end
on the same or approximate vertical grid line for a
seamless look.
4. Select New or Undo until pleased with the stitch.
NOTE: The highlighted area is 9 mm wide. The 9 mm Lock
icon is activated by default. If you wish to design a stit-
wch wider than 9 mm, deselect the 9 mm lock.
C re a t i n g Ne w Stit ches- Snap t o G r id
1.
Touch the New icon to start another stitch.
2. Select snap to grid icon. Snap to Grid makes
it easy to align points as stitch points will
only fall on a dot (note the grid changed to
dots).
3. Select the Draw (pencil) tool.
4. Design stitch by setting points:
• Click 1: to begin stitch
• Click 2: 3 grids down
• Click 3: diagonal line 1 grid up and 1 grid over
• Click 4: diagonal line 1 grid down and 1 grid over
• Click 5: diagonal line 3 grids up and 2 grids over
• Click 6: diagonal line 3 grids down and 2 grids over
• Click 7: diagonal line 1 grid up and 1 grid over
• Click 8: diagonal line 1 grid down and 1 grid over
• Stop
5. Touch the Select All icon. Selected stitches are blue,
and the Selection Icon changes to the selected choice.
6.
Select Duplicate; the duplicate is added after the
original pattern.
Notes:
The Delete icon (Trash Can) deletes whatever is selected--a
single point, all or partial-whatever is blue is selected.
B E R N I N A S E W I N G M A C H I N E W O R K B O O K
47